HOOVER^® Turbo Air Upright Vacuum Cleaner

Experiencing some suction loss? Follow this nifty guide to get your Hoover back to sucking-up-a-storm again:

Check to see if the filter or nozzle is clogged.

1. Turn off the unit and disconnect the nozzle to remove the debris.
2. Check the hose for any built-up debris, and use the handle of a broom to remove.
3. After checking the hose, securely connect the hose to your vacuum. We also recommend checking the filter by removing it from your vacuum and tapping out any built-up debris that could be resting on it.
4. Rinse the filter with water until the water runs clear and allow a dry time of 24 – 36 hours.
5. Alternatively, we recommend checking to see if your filter is clogged. Turn off the unit and disconnect the nozzle to remove any debris.

How do I clear a clog in my bagless upright vacuum?

1. Start by unplugging your vacuum. If you have a cordless vacuum, remove the battery.
2. Then check your bag or dirt cup and empty it if it’s full.
3. Before you reattach the dirt cup, check the elbow pipe for clogs.
4. Next, check your filter and rinse or replace it if it’s dirty.
5. Be sure to let your rinseable filter dry for at least 24 hours.
6. Now we can inspect the hose for clogs. Detach it from the bottom then stretch it to look for obstructions.
7. If the hose comes off completely, Use a long, blunt object to push out any clogs.
8. Finally, remove your wand and make sure it’s clear of obstructions.

How to change your vacuum belt

1. Turn your vacuum over. 
2. Use a screwdriver to take off the 8 screws. Some models only require 6 screws.
3. Remove the bottom plate. 
4. Then take off that old belt. Slide on a new belt with the lettering on the outside. Slip the belt around the brush roll in area without bristles and metal pin. Each end of the brush roll will fit into pockets on each side of the nozzle.
5. Put the plate back on and screw together.

Information about the batteries

Charging your hand vacuum

• If you are using the hand vacuum for the first time, make sure that the switch is in the “OFF” position and charge until the indicator light turns OFF, max. 6 hours.
• Plug the charger into the wall outlet. Place the unit in the charging base. The charging indicator light will illuminate to show that the vacuum is being charged.
• After the initial charge, discharge the battery and charge until the indicator light turns OFF, max. 6 hours.